VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
+ 3. Transmission
- 4. Running gear
   + Wheels and tires
   + Forward suspension bracket
   - Back suspension bracket
      Removal and installation of the back sensor of level of a body of G76/G77
      Suspension bracket of back wheels
      Removal and installation of an amortization rack
      Wheel support
      Removal of a nave of a wheel with the bearing
   + Tables
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes



Volkswagen Touareg / Touareg repair>> Running gear>> Back suspension bracket>> Removal of a nave of a wheel with the bearing
ATTENTION
Disconnected stabilizers before the beginning of works are necessary for including. Otherwise inadvertent turning on of stabilizers can lead to a trauma.

At first remove a power shaft.

Fig. 4.76 . Disk fixing


Fix a brake disk a wheel bolt (fig. 4.76) .
Remove a support and suspend on a wire to a body
Remove a brake disk.
Rasklipsuyte wire of the sensor of frequency of rotation.
Remove the sensor of frequency of rotation of ABS system.
Remove cables of the parking brake from the case of the bearing of a nave
Remove blocks of the parking brake
Fasten T10205/12 captures by means of wheel bolts to a wheel nave.

Fig. 4.77 . Scheme of installation of wheel bolts


Wheel bolts 2 should not act on the back party of captures of T10205/12 (fig. 4.77) .

Fig. 4.78 . Special tool installation: 1–a core with carving М20; 2–a nut with carving М20; 3–press head; 4–hydraulic cylinder; 5–glass; 6–captures; 7–press cracker; 8–a nut with carving М20; 9–a core with carving М20


Establish tools, as is shown in drawing 4.78 .
Extend a wheel nave with the bearing, thus strong hold the adaptation.

Press fitting of a nave of a wheel with the bearing
Establish tools, as is shown in drawing 4.78 .
Connect a manometer with the VAS 6179/1 pipeline between the hydraulic VAS 6178 cylinder and the VAS 6178 hydrocylinder pipeline.
The values of pressure specified below, belong only to the VAS 6178 hydrocylinder.
Before the completion of process of a press fitting the manometer should show pressure in the range from 90 to the 140th bar.
The maximum pressure at a press fitting should not exceed the 310th bar.
Press a wheel nave against the stop.
Establish a power shaft.
Further installation is carried out in return sequence.



<