VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
+ 3. Transmission
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
- 7. Onboard electric equipment
   + General information
   + Generator and starter
   + Combination of devices
   + Forward screen wiper
   - Headlights
      Removal and installation of headlights
      Correction of provision of a headlight
      Removal and installation of the servo-driver of the proof-reader of headlights
      The main headlights with gas-discharge lamps
   + Tables
+ 8. Body
+ electric equipment Schemes


Volkswagen Touareg / Touareg repair>> Onboard electric equipment>> Headlights>> Removal and installation of headlights

Fig. 7.88 . Components of a forward headlight: 1–left servo-driver of the proof-reader of headlights or right servo-driver of the proof-reader of headlights; 2–fixing bolts; 3–cap; 4–left lamp of a passing beam or right lamp of a passing beam; 5–left lamp of a driving beam or right lamp of a driving beam; 6–cap; 7–cap; 8–the lamp boss with the handle; 9–left lamp of a parking light or right lamp of a parking light; 10-for the left lamp of the forward index of turn or the right lamp of the forward index of turn; 11-headlight; 12-adjusting plug; 13-fixing bolts; 14-headlight fastening; 15-a fixing loop; 16-fiksatorny bolt; 17-adjusting plug; 18-fixing bolts; 19-shtekerny connection; 20-lock bracket; 21-shaft of a drive of adjustment of turn of a driving beam; 22-a shaft of a drive of adjustment of near and far light on height; 23-fixing bolts


NOTE
Check factors which influence adjustment of headlights, if necessary – adjust headlights.

NOTE
To disconnect weight from the storage battery not obligatory.

In drawings it is shown removal and installation of the left headlight.

Removal
Switch off ignition and all electric consumers, take the ignition key.
Press a headlight.

Fig. 7.89 . Fiksatorny bolt


Turn a fiksatorny bolt in the direction the arrows Open (sticker) resistance (fig. 7.89) will not be felt yet .

NOTE
Turn a bolt, without applying force, differently there is a risk to break the clamp mechanism.
The headlight is pushed out forward.

Pull a headlight from a niche in a wing, the emphasis will not be felt yet.

Fig. 7.90 . Lock bracket


Hold a lock bracket 1 in the pressed situation, take a headlight from body cut (fig. 7.90) .

Installation
Establish a headlight in the directing.

NOTE
In the directing there should not be pollution.


Whether check densely the tip 1 in headlight fastening is fixed before inserting a headlight in directing (fig. 7.91) .

Accurately push a headlight in body cut.

NOTE
"Accurate" click should be audible. It means that the lock bracket is fixed.

Turn a fiksatorny bolt in the direction the arrows Close (sticker) resistance (fig. 7.89) will not be felt yet .
Slightly press on a headlight and turn a bolt further in the direction the arrows Close (sticker).
The fixing bracket should be latched with clearly audible click.
Check headlight installation on identical lateral gaps.
In case between a headlight and a body non-uniform, the provision of a headlight is necessary to modify gaps.
Check headlight work, including all its functions.
Check control of headlights, if necessary – adjust.


<