Management of screen wipers and stekloomyvatel is carried out by means of the podrulevy switch.

Fig. 1.45 . Podruleva lever of screen wipers and stekloomyvatel

Faltering movement of brushes (windshield)

Shift the lever up in the fixed situation 1.

For installation of an interval of movement turn A.Povorot's disk regulator up – pauses shorter, from top to bottom – is longer. At turn the longest work of screen wipers up is against the stop reached.

Faltering movement of a brush (back glass)

Wring out the lever forward. The screen wiper works each six seconds.

Draw in the lever completely forward for turning on of automatic equipment of cleaning and обмыва back glass.

Release the lever. The screen wiper works four more seconds, then starts to work each six seconds.

Slow movement of brushes

Shift the lever up in the fixed situation 1.

– Turn a disk regulator of A against the stop up.

Long movement of brushes

Shift the lever up in the fixed situation 2.

Manual control by screen wipers

Shift the lever down in situation 3 when it is necessary to include screen wipers quickly only.

Automatic equipment of cleaning and обмыва (windshield)

Pull the lever quickly in situation 4.

Release the lever. Screen wipers work four more seconds.

Switching off of screen wipers

Shift the lever in a starting position 0.

Screen wipers and stekloomyvatel work only at the included ignition.

ATTENTION Worn-out and dirty brushes of screen wipers do not provide good visibility that reduces traffic safety. At low temperatures include stekloomyvatel only after windshield warming by means of heating and supply of warm air. Otherwise liquid for stekloomyvatel can freeze on a windshield and limit visibility. In the winter before the first inclusion of screen wipers be convinced that brushes did not freeze to glass. Otherwise, if brushes froze, can be damaged both brushes, and electric motors of a drive of screen wipers.

Rain sensor

Fig. 1.46 . Adjustment of the sensor of a rain

The sensor of a rain regulates intensity of work of screen wipers depending on a rain stream (fig. 1.46) .

Turning on of the sensor of a rain

Shift podrulevy the lever in situation 1.

Establish a disk regulator of A according to desirable sensitivity of the sensor of a rain. At regulator turn up – sensitivity is higher. At ring turn from top to bottom – sensitivity is lower. At turn of a disk regulator slow long work of screen wipers up is against the stop reached.

The sensor of a rain operates faltering movement of brushes. If ignition was switched off, it is necessary to establish adjustment of the sensor of a rain anew. For this purpose it is necessary to switch off and again to include faltering movement of brushes.

Washers of headlights

Washers of headlights clear headlights.

At inclusion of stekloomyvatel also work washers of headlights in case to bring podrulevy the lever to a steering wheel at least for one and a half seconds at the included passing or driving beam. Regularly, for example, when fuelling, clean off from headlights the dried dirt (for example, remains of insects).

NOTE For ensuring normal work of washers of headlights during the winter period clear holders of nozzles in a bumper of snow and delete ice from the help of spray for ice removal.

Sun-protection peaks

Fig. 1.47 . Sun-protection peaks on a place of the driver

One of dual peaks on a place of the driver can be taken out from fastening on the right and to move it to a door (fig. 1.47) .

The cosmetic mirror in a peak is covered with a cover. When moving cover in a ceiling the lamp lights up.

NOTE Before an exit from the car shift a cover into place. It prevents the accumulator category.