Joint stock bank shutdown

Slightly press the facing panel down and at the same time back.

NOTE For shutdown of joint stock bank there should be деактивирована an anticreeping alarm system. Untwisting of the minus plug from the storage battery (the current termination in a chain) – secure works on electric equipment. To turn off the plusovy plug it is necessary only for dismantle of the storage battery. Switch off ignition and all electric consumers, take the ignition key. Dismantle of facing panels under a driver's seat

Fig. 7.4 . Clamps of the facing panel

NOTE Clamps of A cling to a cross-section extension under a seat (fig. 7.4) .

Hold the panel in this situation and with lock uvulas of A. Pull it up that release.

Clamps of B will get to grooves in a cross-section extension before a seat. Unblock them it is possible also, having pressed down and having pulled on itself.

Clamps of C hold the lateral facing panel of a seat, having pulled on itself, they can be unblocked.

Establish a seat in back, top situation.

Fig. 7.5 . Unblocking of clamps

Unblock clamps in pressing down and back at the same time. In such situation raise the facing panel in the field of clamps (fig. 7.5) .

Press on the facing panel down and at the same time pull it on itself.

Fig. 7.6 . Raising of the forward panel

Accurately raise the panel 1 by means of a screw-driver from the forward facing panel of an axis of adjustment of a seat (fig. 7.6) .

Fig. 7.7 . Removal of the forward panel of the panel

Remove the forward panel of an axis of adjustment of a seat from a seat sled (fig. 7.7) .

Establish a seat in forward, top situation.

NOTE Installation and dismantle of back facing panels of axes of adjustment of a seat is carried out equally on both parties.

Fig. 7.8 . Raising of the back panel

Accurately raise the panel 1 by means of a screw-driver from the back facing panel of an axis of adjustment of a seat (fig. 7.8) .

Fig. 7.9 . Removal of the back panel

Remove the back panel of an axis of adjustment of a seat from a seat sled (fig. 7.9) .

Release clamps of the lateral facing panel of the console of a seat by means of a screw-driver and take the panel, having pulled it up.

Fig. 7.10 . Panel unblocking

Unblock panels (fig. 7.10) .

Fig. 7.11 . Fixing bolts

Unscrew fixing bolts (fig. 7.11) .

Cast away the seat basis together with a seat back.

Fig. 7.12 . Bolt of fastening of an air line

Unscrew a bolt 1 and remove an air line 2 (fig. 7.12) .

Fig. 7.13 . Locks clamps

Open locks clamps of a box of joint stock bank of an arrow and uncover (fig. 7.13) .

Turn off the minus plug and plusovy plugs from joint stock bank conclusions.

Joint stock bank connection

Put on the plusovy plug on plusovy a joint stock bank conclusion.

ATTENTION Dress polar plugs a hand without effort not to allow damages of the case of the storage battery. It is forbidden to grease conclusions of the storage battery.

Tighten the fixing screw of the plusovy plug with the ordered moment of an inhaling

Only after the positive plug was fixed, it is possible to put on the negative plug the corresponding conclusion of the storage battery.

Tighten the fixing screw of the minus plug with the ordered moment of an inhaling.

Replace fixing bolts of the basis of a seat and twirl them with the ordered moment of an inhaling