VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
+ 3. Transmission
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
- 7. Onboard electric equipment
   + General information
   - Generator and starter
      Removal and starter installation (6-цил. the engine with injection of 3,2 l and the engine of 3,6 l of FSI, AKPP)
      Removal and starter installation (8-цил. the engine with injection of 4,2 l, AKPP)
      Removal and starter installation, 10-tsil. TDI engine of 4,9 l, AKPP
      Three-phase generator
      Removal and installation of the three-phase generator, with air cooling, 6-цил. the engine with injection
      Removal and installation of the three-phase generator, 8-цил. the engine with injection
      Removal and installation of a regulator of tension
   + Combination of devices
   + Forward screen wiper
   + Headlights
   + Tables
+ 8. Body
+ electric equipment Schemes



Volkswagen Touareg / Touareg repair>> Onboard electric equipment>> Generator and starter>> Removal and starter installation (6-цил. the engine with injection of 3,2 l and the engine of 3,6 l of FSI, AKPP)
Removal
Disconnect joint stock bank.
Remove a noise isolation.

Fig. 7.24 . Thermal insulation of the magnetic switch


Open buttons and remove a thermal insulation of the magnetic switch (fig. 7.24) .
Hook protective caps of fixing nuts.

Fig. 7.25 . Fixing nut of a plusovy cable


Turn off a fixing nut of a plusovy cable from the electromagnetic switch of a starter (fig. 7.25) .

Fig. 7.26 . Fixing nut of the plug of a cable 50 electromagnetic switches of a starter


Turn off a fixing nut of the plug of a cable 50 from the electromagnetic switch of a starter (fig. 7.26) .

ATTENTION
Probably perekruchivany wires with screw connection.
The magnetic switch can be damaged.
During the untwisting and a twisting of a positive wire and the plug of a wire 50 fix a wrench screw connection with the magnetic switch.

Fig. 7.27 . A fixing bolt of a starter of M12х60 on the engine party


Unscrew the bottom fixing bolt of a starter of M12х60 on the engine party (fig. 7.27) .

Fig. 7.28 . Fixing bolt of the holder of cables


Unscrew a fixing bolt 2 holders of cables and put a cable aside (fig. 7.28) .
Turn off fixing nuts 1.

Fig. 7.29 . Fixing bolt of the holder of system of release of OG


Turn off from the engine a fixing bolt of 1 holder of system of release of OG 2 and remove its (fig. 7.29) .

Fig. 7.30 . A fixing bolt of tubes of system of cooling on the oil pallet of the engine


Turn off a fixing bolt of tubes of system of cooling on the oil pallet of the engine (fig. 7.30) .

Fig. 7.31 . The top fixing bolt of a starter on the transmission party


Unscrew the top fixing bolt of a starter on the transmission party (fig. 7.31) .
Take a starter.

Installation
Installation is carried out in return sequence, thus it is necessary to consider the following.
Tighten connections with the ordered moment of an inhaling


<