Removal

Fig. 7.60 . Contour of a poliklinovy belt 8-цил. the engine with injection: 1–a pulley of klinoremenny transfer – the three-phase generator; 2–tension roller; 3–a pulley of klinoremenny transfer – a cranked shaft; 4–by-pass roller; 5–a pulley of klinoremenny transfer – the conditioner compressor; 6–a pulley of klinoremenny transfer – the krylchaty pump of the amplifier of the steering mechanism; 7–a poliklinovy driving belt – the three-phase generator, by-pass a roller, the conditioner compressor, the krylchaty pump of the amplifier of the steering mechanism, a cranked shaft, the pump of system of cooling and a tension roller

Remove the engine.

Fig. 7.61 . Weakening of a tension of a poliklinovy belt

Weaken a poliklinovy driving belt, having turned a tension element by means of a cap wrench of SW 19 (fig. 7.61) .

Fix a tension element by means of a lock pin of T10060 A.

Fig. 7.62 . Tip of a wire of DF

Disconnect the tip of a wire of DF (fig. 7.62) .

Fig. 7.63 . Protective cap

Remove a protective cap (fig. 7.63) .

Fig. 7.64 . Fastening of a wire of B +

Turn off B wire + from the generator (fig. 7.64) .

Fig. 7.65 . Holder of tubes of system of cooling

Unscrew a fixing bolt 1 and remove the holder of 2 tubes of system of cooling from the generator (fig. 7.65) .

Take tubes of system of cooling 3 of the generator.

Fig. 7.66 . Fixing bolts of M8х90 of the generator

Unscrew fixing bolts of M8х90 of the generator (fig. 7.66) .

Installation

Installation is carried out in return sequence, thus it is necessary to consider the following.

Tighten connections with the ordered moment of an inhaling.

Replace sealing rings of tubes of supply of cooling liquid.