Fig. 3.184 . A press fitting of the internal hinge on a power shaft

Press the internal hinge on a power shaft, as is shown in drawing 3.184 .

Establish on a power shaft a new lock ring by means of a grip for spring lock rings of VW of 161 A.

Establish on the internal hinge a new cover.

Fig. 3.185 . Installation of a tightening grip

Tightening grip of V.A.G 1682 establish, as is shown in drawing 3.185 .

Thus watch that edges of a grip adjoined to corners of B of a collar.

Tighten a collar, rotating the screw a dinamometrichesky key (thus the distortion of a grip is not allowed).

NOTE Because of firm (in comparison with rubber) a material of the boot, a collar demanding use from high-quality steel, the collar can be tightened only a tightening grip of V.A.G 1682.

Inhaling moment: 25 N · m.

Use a dinamometrichesky natural a range of regulation of 5-50 N · m (for example a dinamometrichesky key of V.A.G 1331).

Watch that the carving of the screw A of a grip rotated easily. If necessary grease with plastic MOS 2 greasing.

At the complicated rotation, for example because of carving pollution, at the set moment of an inhaling the effort of a clip of a collar will be less necessary.