Liquid pumping from the hydrotransformer

Hydrotransformer installation

Repair of a drive of gear shifting

Removal and installation of the handle of the selector

Check and adjustment of draft of the selector

Removal and installation of draft of the selector

Removal and slip installation

Removal and frame installation

Removal and installation of an electromagnet of blocking of the N110 selector

Removal and installation of the switch of the selector (the lever is blocked in the situation "P") F319

Removal and installation of a drive of gear shifting

Removal and transmission installation, cars with the diesel R5 engine

Removal and transmission installation, cars with petrol V6 and V8 engines, turbodiesel engines V6 TDI, V10 TDI and the petrol W12 engine

Inhaling moments

Removal and installation of highways and ATF radiator

Removal and installation of the control unit of an automatic transmission of J217

Replacement of a sealing ring of a secondary shaft

Removal and installation of the oil pallet

Removal and installation of the mesh oil filter

Removal and installation of the sensor of pressure for hydrosystem 1 in AKP G193 and the pressure sensor for hydrosystem 2 in AKP G194

Removal and installation of a zolotnikovy box

Removal, installation and adjustment of the multipurpose F125 switch

Fig. 3.4 . Hydrotransformer nave

Check a hydrotransformer nave on existence of wear tracks (fig. 3.4) .

NOTE The hydrotransformer – not folding unit (is made) and at damage is subject to replacement.

Removal of a sealing koltsagidrotransformator

Enter a stripper of VW 681 directly behind a working edge of a sealing ring so that not to damage the driven ring which was behind it.

Installation

Grease external perimeter and working edges of a sealing ring with ATF oil.

Assembly situation: the open party of a sealing ring to a transmission.

Press a sealing ring of the hydrotransformer by means of an opravka 3295 against the stop opravka.