NOTE The Tiptronic-F189 switch – is built in a plait of wires of two electromagnets.

Removal

Remove the selector handle.

It is necessary to observe sequence of shutdown of joint stock bank surely.

Disconnect the mass plug from joint stock bank at the switched-off ignition.

Remove an overlay of the central console.

Fig. 3.22 . Bolts of the central console

Unscrew bolts of the central console (fig. 3.22) .

Unblock and disconnect shtekerny connection 1.

Unscrew a bolt 2 and remove the holder.

Fig. 3.23 . Shtekernye connections and bolt

Take shtekerny connection 3 of the holder (fig. 3.23) .

Disconnect shtekerny connections from electromagnets.

Fig. 3.24 . Lock lever

Press the lock lever to the right and pull the switch up-forward from a gear shifting drive (fig. 3.24) .

Installation

Installation is carried out in return sequence. Thus it is necessary to consider the following.

Fig. 3.25 . Cables: 1–a plait of wires to an electromagnet of blocking of the N110 selector; 2–a plait of wires to an electromagnet of blocking of the selector in the situation "P" N380; 3–a plait of wires to the selector switch (the lever is blocked in the situation "P") F319

To lay cables 1–3 how it is shown in drawing (fig. 3.25) .

Establish shtekerny connection 3 in the holder.

Tighten a bolt 2.

Connect the tip 1 (fig. 3.23) .

Establish an overlay of the central console.

Connect joint stock bank.

Establish the selector handle.