VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
- 3. Transmission
   + 6-step automatic transmission 09D
   - Hydrotransformer check
      Liquid pumping from the hydrotransformer
      Hydrotransformer installation
      Repair of a drive of gear shifting
      Removal and installation of the handle of the selector
      Check and adjustment of draft of the selector
      Removal and installation of draft of the selector
      Removal and slip installation
      Removal and frame installation
      Removal and installation of an electromagnet of blocking of the N110 selector
      Removal and installation of the switch of the selector (the lever is blocked in the situation "P") F319
      Removal and installation of a drive of gear shifting
      Removal and transmission installation, cars with the diesel R5 engine
      Removal and transmission installation, cars with petrol V6 and V8 engines, turbodiesel engines V6 TDI, V10 TDI and the petrol W12 engine
      Inhaling moments
      Removal and installation of highways and ATF radiator
      Removal and installation of the control unit of an automatic transmission of J217
      Replacement of a sealing ring of a secondary shaft
      Removal and installation of the oil pallet
      Removal and installation of the mesh oil filter
      Removal and installation of the sensor of pressure for hydrosystem 1 in AKP G193 and the pressure sensor for hydrosystem 2 in AKP G194
      Removal and installation of a zolotnikovy box
      Removal, installation and adjustment of the multipurpose F125 switch
   + Mechanical transmission 08D and transfer case Е473
   + Driveshaft
   + Driving mechanism
   + Tables
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes


Volkswagen Touareg / Touareg repair>> Transmission>> Hydrotransformer check>> Removal and installation of the oil pallet
Removal
Remove a transmission noise isolation.
To substitute the pallet V. A. G 1306.

Fig. 3.69 . An opening bolt for oil plum


Remove an opening bolt for oil 1 plum (fig. 3.69) .
Merge ATF oil.
Turn off bolts of the oil pallet 1 «a cross - on - a cross» and remove the oil pallet.

Installation
Clear all electromagnets in fillets of the oil pallet. Watch that electromagnets adjoined all surface to the oil pallet.

Fig. 3.70 . Laying and rasporny plug


Establish the oil pallet with new laying 1 (fig. 3.70) .
Watch that all rasporny plugs 2 were completely in new laying 1.
Tighten bolts of the oil pallet in some stages «a cross - on - a cross»
Replace a sealing ring of a bolt of an opening for oil plum.
Tighten an opening bolt for oil plum.
After installation fill in ATF, then check ATF level, if necessary – add oil.

Inhaling moments
Opening bolt for oil plum: 28 N · m.
Bolts of the oil pallet: 8 N · m.


<