VW Touareg repair
+ 1. Operation and car maintenance
+ 2. Engine
- 3. Transmission
+ 6-step automatic transmission 09D
- Hydrotransformer check
Liquid pumping from the hydrotransformer
Repair of a drive of gear shifting
Removal and installation of the handle of the selector
Check and adjustment of draft of the selector
Removal and installation of draft of the selector
Removal and slip installation
Removal and frame installation
Removal and installation of an electromagnet of blocking of the N110 selector
Removal and installation of the switch of the selector (the lever is blocked in the situation "P") F319
Removal and installation of a drive of gear shifting
Removal and transmission installation, cars with the diesel R5 engine
Removal and transmission installation, cars with petrol V6 and V8 engines, turbodiesel engines V6 TDI, V10 TDI and the petrol W12 engine
Removal and installation of highways and ATF radiator
Removal and installation of the control unit of an automatic transmission of J217
Replacement of a sealing ring of a secondary shaft
Removal and installation of the oil pallet
Removal and installation of the mesh oil filter
Removal and installation of the sensor of pressure for hydrosystem 1 in AKP G193 and the pressure sensor for hydrosystem 2 in AKP G194
Removal and installation of a zolotnikovy box
Removal, installation and adjustment of the multipurpose F125 switch
+ Mechanical transmission 08D and transfer case Е473
+ Driving mechanism
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes
Volkswagen Touareg / Touareg repair>> Transmission>> Hydrotransformer check>> Removal and installation of an electromagnet of blocking of the N110 selector
Remove a gear shifting drive.
Unblock and disconnect shtekerny connection.
Unblock an electromagnet in fastening and take it from the blocking lever 1 and a gear shifting drive (fig. 3.20) .
Put the lever of an electromagnet 2 vertically up.
Push an electromagnet in front in fastening of a drive of gear shifting.
Connect the lever 2 to the blocking lever 1 (fig. 3.20) .
Push an electromagnet against the stop in a gear shifting drive while it will not be fixed in the fastening (fig. 3.21) .
Check that the electromagnet is established in fastening against the stop and the lever is in gearing with the blocking lever.