NOTE Always replace sensors together.

Removal

If this operation is not executed yet – remove the oil pallet and the mesh oil filter.

Fig. 3.73 . Shtekernye of connection of sensors

Carefully disconnect tips of the sensor of pressure for hydrosystem 1 in AKP G193 1 and the pressure sensor for hydrosystem 2 in AKP G194 2 (fig. 3.73) .

Unscrew both sensors.

Installation

Always replace sensors together.

Establish two new sensors and tighten with the moment of 5 N · m.

Connect tips of sensors 1 and 2 against the stop.

Tips should click.

Establish the mesh oil filter and the oil pallet.

After installation fill in ATF, then check ATF level, if necessary – add oil.