Removal

Remove a slip.

Fig. 3.16 . Frame clamps

Pull clamps at the left and on the right outside and pull a frame up (fig. 3.16) .

Installation

Installation is carried out in return sequence.

Establish a slip.

Selector switching in the absence of a food from the situation "P" – an emergency unblocking.

Fig. 3.17 . Screw-driver installation site

Press the magnet core from above by means of a long, thin screw-driver in the arrow direction (fig. 3.17) .

For this purpose there is no need to remove the handle.

Removal and installation of an electromagnet of blocking of the selector in the situation "P" N380.

Removal

Remove a gear shifting drive.

Unblock and disconnect the tip.

Fig. 3.18 . The blocking lever of a drive of gear shifting

Unblock an electromagnet in fastening and pull up outside from the blocking lever 1 and a gear shifting drive (fig. 3.18) .

Installation

Put the lever of an electromagnet 2 vertically up.

Establish an electromagnet at a small angle in fastening of a drive of gear shifting.

Connect the lever 2 to the blocking lever 1 (fig. 3.18) .

Push an electromagnet against the stop in a gear shifting drive while it will not be fixed in the fastening of the shooter.

Fig. 3.19 . Installation рачага

Check that the electromagnet is established in fastening against the stop and the lever 2 is in gearing with the blocking lever 1 (fig. 3.19) .