VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
- 3. Transmission
   + 6-step automatic transmission 09D
   + hydrotransformer Check
   + Mechanical transmission 08D and transfer case Е473
   - Driveshaft
      Removal and installation of the forward driveshaft
      Removal and installation of the back driveshaft
      Check of level of oil in back the main thing to transfer
      Removal of forward main transfer
      Laying of a ventilating tube of forward main transfer
      Replacement of a sealing ring of the left shaft with a flange
      Replacement of a boot of a shaft with a flange
      Replacement of a rezinometallichesky support of forward main transfer
      Replacement of the left sealing ring of a shaft with a flange for cars without differential blocking
      Replacement of the left sealing ring of a shaft with a flange for cars with differential blocking
   + Driving mechanism
   + Tables
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes
Volkswagen Touareg / Touareg repair>> Transmission>> Driveshaft




NOTE
Driveshafts are not subject to repair.
The back driveshaft do not bend, store and transport only in horizontal situation.
Remove the back driveshaft in situation by fastening up.
Before dismantle the provision of all parts on the relation to each other mark. Assembly is carried out in the same situation, differently there is an imbalance that can cause damages of support and be shown in the form of the raised shumnost.
If the forward driveshaft is disconnected only from a transfer case or only from forward main transfer, or the back driveshaft from reverse main gear, the corresponding driveshaft should be adhered or, under it the support should be established.
At complaints to the vibration, extraneous noise of the forward or back driveshaft, before the driveshaft replacement, the corresponding shaft of the main transfer should be displaced on one fixing opening. These works it is possible carry out 5 times on the main transfers and 2 on a transfer case.


Fig. 3.128 . Driveshaft and forward main transfer: 1–forward main transfer; 2–laying 3 – a bolt, 30 N · m 90 °; 4–forward driveshaft; 5–transfer case; 6–six-sided nut; 7–hinge disk; 8–washer; 9–bolt, 75 N · m; 10-back driveshaft; 11-tighten a bolt with an internal asterisk with the moment of 30 N · m and to tighten on 90 °; 12-laying; 13-reverse main gear; 14-holder; 15-bolt, 20 N · m; 16-bolt, 60 N · m; 17-bolt; 18-six-sided nut, 75 N · m




<