Removal

The sequence of actions given further is necessary for observing not to damage the selector handle.

Fig. 3.8 . Removal of a decorative slip

Remove a decorative slip (fig. 3.8) .

Fig. 3.9 . Bracket extraction

Pull out a bracket from the handle (fig. 3.9) .

Extend the button through a certain resistance so that it was fixed.

After that remove the handle from the selector.

Installation

Fig. 3.10 . Scheme of installation of the lever of the selector

At handle replacement at all do not delete the assembly adaptation of the new handle.

If the button was casually pressed and left in the handle – hold the handle vertically and carefully blow the button the compressed air from below while it cannot be extended a hand through a certain resistance.

Again establish the assembly adaptation A (it is delivered together with the handle).

Establish a bracket.

Insert a decorative slip into the handle.

Switch the selector in the situation "N".

I–Carefully carry out the plug through a jalousie and the zaslonka which was below.

Watch that at installation the plug was conducted through protective plates very carefully. By inattentive pressing of the plug protective plates will be destroyed.

II – the Handle get against the stop in the longitudinal direction, then turn.

Assembly situation: the button is directed to the driver.

III – Now get the handle on the selector lever against the stop, click should be thus audible.

Remove the assembly adaptation A, press the button and pull the plug up.

Remove a protective film on a surface of gluing and paste an emblem.