Removal

To remove the sensor of level of a body, it is necessary to dismantle an amortization rack and a basic arm.

Remove an amortization rack.

Removal of the left basic arm

Fig. 4.70 . Fixing bolt

Turn off a bolt under a tank of brake liquid 1 (fig. 4.70) .

Fig. 4.71 . Fixing bolts

Turn off bolts under a tank with oil for hydraulic system 1 (fig. 4.71) .

Removal of the right basic arm

Unblock and remove the tip of the control unit of the engine 2.

Fig. 4.72 . Control unit fastening

Take the control unit (fig. 4.72) .

Remove fastening of the control unit of the engine 2.

Now there is an access to bolts of a basic arm (3 pieces).

Fig. 4.73 . Fastening bolt

Turn off a bolt (fig. 4.73) .

Take a basic arm.

Remove the sensor of level of a body from the top cross-section lever and turn off from a basic arm.

Installation

Installation is carried out in return sequence, thus it is necessary to consider the following.

Fig. 4.74 . Ledge of fastening of the sensor

The ledge of fastening of the sensor of level of a body should adjoin to a basic arm (fig. 4.74) .

Establish a basic arm.

Establish an amortization rack.

Inhaling moments