Fig. 4.82 . Installation of the top support in a cup

Insert the top support 2 into the top cup 1 (fig. 4.82) .

Thus a ledge the arrow A should coincide with deepening – an arrow B.

Establish a spring on the bottom holder of VAS 6046/3.

Fig. 4.81 . The correct provision of a spring in the holder

Watch the correct provision of a spring in the holder of VAS 6046/3 (fig. 4.81) .

Fig. 4.83 . Scheme of installation of a spring

The top cup it is necessary establish on a spring so that the ledge was opposite to fastening of connecting draft 1 (fig. 4.83) .

Lines of cents of A and B should be parallel each other.

Fig. 4.84 . Correct provision of the end of a spring

The end of a spring should adjoin to an emphasis of the top support 1 (fig. 4.84) .

Watch that the boot was clamped in the top cup of a spring 2.

On a rod of the piston tighten a new six-sided nut.

Unclench a coupler of VAS 6046 and remove it from a spring.

Establish an amortization rack.

Inhaling moment

Nut of an amortization rack (Use new nuts) – 60 N · m