Procedure for test

To carry out measurements follows at the removed support and roller levers.

Fig. 2.117 . Order of installation of kyshka of bearings

Enclose a cam-shaft and fasten covers of bearings 3, 5 and 7 (fig. 2.117) .

Inlet cam-shaft

Fig. 2.118 . Indicator installation for check of an inlet cam-shaft

Arrange the universal holder with the strelochny indicator on GBTs, as is shown in drawing 2.118 .

Axial gap, limit of wear: Max. 0,20 mm.

Final cam-shaft

Fig. 2.119 . Indicator installation for check of a final cam-shaft

Arrange the universal holder with the strelochny indicator on GBTs, as is shown in drawing 2.119 .

Axial gap, limit of wear: Max. 0,20 mm.