VW Touareg repair


+ 1. Operation and car maintenance
- 2. Engine
   + Preliminary checks on the car
   + Mechanical part (petrol engines 3,2L)
   - Mechanical part (petrol engines 4,2L)
      Check of directing plugs of valves
      Replacement of an epiploon of a cranked shaft on the party of a damper of krutilny fluctuations
      Removal and installation of a leading disk
      Removal and flange installation on the party of a leading disk
      Removal, installation and tension of a gear belt of a drive of GRM
      Check of an axial gap of cam-shafts
      Replacement of epiploons of cam-shafts
      Replacement of epiploons of sensors of the Hall
      Removal and installation of cam-shafts and regulators of phases of a gazoraspredeleniye
   + Mechanical part (diesel engines 5,0L)
   + Removal and stretcher installation
   + pressurization System (diesel engines)
   + cooling System (petrol engines)
   + cooling System (diesel engines)
   + greasing System (petrol engines)
   + greasing System (diesel engines)
   + injection System (petrol engines)
   + injection System (diesel engines)
   + System of production of the fulfilled gases
   + System топливоподачи (beninovy engines)
   + Tables
+ 3. Transmission
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes



Volkswagen Touareg / Touareg repair>> Engine>> Mechanical part (petrol engines 4,2L)>> Replacement of epiploons of sensors of the Hall
Works order (the left head of the block of cylinders)
Disconnect tips of coils of ignition and nozzles of injection of fuel and put aside wires.
Disconnect the tip from the Hall sensor.
Remove the sensor case together with a cap and a cone.

Right head of the block of cylinders
Remove the right cover of a gear belt.
Disconnect the tip from the Hall sensor.
Turn off bolts 1 from the Hall sensor.

Fig. 2.122 . Bolts of fastening of the sensor and back cover of a gear belt


Turn off bolts 2 from a back cover of a gear belt (fig. 2.122) .
Pull a back cover of a gear belt slightly forward and remove the case of the sensor of the Hall together with a cap and a cone.

Fig. 2.123 . Finger installation


Twirl a finger 2085/1, as is shown in drawing 2.123 .

Fig. 2.124 . Installation of a stripper of an epiploon


Unscrew an internal part of a stripper of an epiploon 2085 on some turns from an external part and fix a bolt with a nakatanny head (fig. 2.124) .
Grease a carving head of a stripper with engine oil, put and, having strongly pressed it, screw as it is possible more deeply in an epiploon.
Weaken a bolt with a nakatanny head and scroll an internal part of a stripper against a finger 2085/1 while the epiploon will not be removed.
Clamp an epiploon stripper on flat edges in a vice. With pincers remove an epiploon.

Fig. 2.125 . Epiploon press fitting


In summary press a new epiploon an opravka 3241/1 and a bolt 3241/3 aflush (fig. 2.125) .
Further installation is carried out in return sequence.


<