Removal

The left and right steering drafts are identical.

Their removal and installation are carried out without steering dismantle.

Turn off a forward wheel.

Squeeze out cross-section steering draft from the case of the bearing of a nave of a wheel.

Clear a drive of the amplifier of a steering outside in a boot zone.

Open a collar and shift a collar back.

Fig. 5.15 . Untwisting of steering draft

Turn off steering draft by means of a wrench and an insert (fig. 5.15) .

Installation

Installation is carried out in return sequence, thus it is necessary to consider the following.

Tighten steering draft by means of a wrench and an insert.

Check a boot on wear (furrows, cracks), and contact surfaces of a boot – on absence of pollution.

Establish a boot and a collar.

NOTE Use only an original collar.

Fig. 5.16 . Collar installation

Clamp a collar by means of a tightening grip of VAS 6199, as is shown in drawing 5.16 .

Further installation is carried out in return sequence.

Execute base setup of the sensor of an angle of rotation of a steering wheel of G85.

Inhaling moments

The cross-section lever to the case of the wheel bearing (use a new nut) – 90 N · m.

Steering bent for to the steering mechanism – 100 N · m.