VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
+ 3. Transmission
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
- 8. Body
   - External elements of a body
      Removal and cowl installation
      Removal of a gas emphasis
      Production of gas from a gas emphasis
      Removal and isolation installation
      Removal and installation of the lock of a cowl
      Adjustment of the lock of a cowl
      Detachment of a flexible cable
      Removal and installation of a door of a luggage compartment
      Adjustment of a door of a luggage compartment with the hinge
      Adjustment of a loop of the lock
      Removal and installation of a cap of a gas emphasis
      Removal and installation of a cap of a gas emphasis
      Removal and installation of elements of locking and door unlocking
      Removal and installation of the lock of a door of a luggage compartment
      Removal and installation of a loop of the lock with a dovodchik
      Removal and installation of the electric motor of opening of a door of a luggage compartment
      Removal and installation of a back spoiler
      Removal and installation of elements of locking and unlocking of the hatch of a fuel tank
      Door adjustment
      Removal and installation of the case of the cylinder of the lock
      Removal and installation of the handle of a door
      Removal and installation of the lock of a door
      Adjustment of a back door
      Removal and installation of the case of the cylinder of the lock
      The elevating and movable hatch with the glass panel
      Removal of the glass panel of the elevating and movable hatch
      Check of a parallel course of the glass panel
      Adjustment of a sealant of the panel of the hatch
      Removal of the sun-protection screen
      Removal and installation of facing of a front bumper
      Removal and installation of facing of a rear bumper
+ electric equipment Schemes


Volkswagen Touareg / Touareg repair>> Body>> External elements of a body>> Adjustment of a back door
For the correct adjustment of a door, it is necessary to weaken the door hinge on a rack. Other measures as a door tightening up, are inefficient. At the subsequent loading the door again will give.
For these purposes use a key for adjustment of a door 3320 together with a nozzle 3320/2.
If necessary to turn off the top hinge of a door on a rack In from within, it is possible to use a nozzle adapter 3320/1.
For this purpose it is necessary to remove rack facing In and an overlay for a threshold.
At installation of a new external covering of a door the framework of hinged units is not mentioned.

Fig. 8.40 . Adjustment of a back door


The back edge of an external covering of a door is established above approximately on 1 mm of rather back door, the size a (fig. 8.40) .
After installation of a framework of hinged units the door falls by 1 mm.


<