Removal

Fig. 8.41 . Cap extraction

Poddvev a cap, take out it from an opening (fig. 8.41) .

Fig. 8.42 . Extraction of the case of the cylinder of the lock

Pull for the handle of a door 1 and hold it. Unscrew a bolt 3 by means of a face key of T 10072 against the stop. Thus you release the case of the cylinder of the lock 2 (fig. 8.42) .

Now it is possible to take out the case of the cylinder of the lock 2 at right angle to a door from fastening of the door handle in the direction.

Installation

Insert the case of the cylinder of the lock 2 at right angle into fastening of the door handle.

Now twirl a face key a bolt 3 in fastening (fig. 8.42) .

Distinct click testifies that the door handle was again fixed in the case of the cylinder of the lock.

NOTE In an installation time the case of the cylinder of the lock should be pressed to an external covering of a door from the inside. The door handle 1 is established on a door leaky.

Further installation is carried out in return sequence.

In summary it is necessary to check operation of the door handle and the lock as at the wrong adjustment and fixing of a flexible cable the door can not open.