VW Touareg repair


+ 1. Operation and car maintenance
+ 2. Engine
+ 3. Transmission
+ 4. Running gear
+ 5. Steering mechanism
- 6. Brake system
   - General information
      Plate example with car data
      Forward brakes
      Back brakes
      Check of brake system
      Pumping of brake system
      Pumping (main)
      Additional pumping
      Sequence of pumping
      Removal and installation of a potentiometer of a course of a membrane of the amplifier of brakes of G420
      Removal and installation of the vacuum pump of brakes of V192
      Removal and installation of the sensor of pressure of the amplifier of brakes of G294
      Removal and installation of the main brake cylinder
      Removal and installation of the amplifier of brakes
      Repair of brake pipelines
      Repair of brakes of forward wheels, brake support of Brembo 17’’ (1LC)
      Removal and installation of brake shoes
      Repair of brakes of back wheels, brake support of FN 44
      Removal and installation of brake shoes
      Adjustment of the parking brake
      Adjustment of brake shoes on two wheels
      Check of a free wheeling of the lever of the pedal parking brake
      Removal and installation of the lever of the pedal parking brake
      Removal and installation of back brake cables
      Detachment of a pedal of a brake from the amplifier of brakes
      Connection of a pedal of a brake with the amplifier of brakes
      Removal, installation and adjustment of the switch of signals of braking
      Anti-blocking system (ABS)
   + Tables
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes



Volkswagen Touareg / Touareg repair>> Brake system>> General information>> Removal and installation of the main brake cylinder
Removal
Remove a covering of a water taking away box.
Remove consolidation of a motor compartment and a level in the field of the amplifier of brakes.
Remove a wall from a water taking away box.
Put in water taking away box in the field of the main brake cylinder enough of not leaving fibers of rags.
Pump out the greatest possible amount of brake liquid by means of the device for filling and VAS 5234 or adaptation pumping for pumping out of V.A.G liquid 1869/4 of a tank of brake liquid.
Remove the tip from the sensor of the precautionary indicator of a float.
Remove the tip from the pressure sensor in brake system.
At cars with a mechanical transmission remove a hose of the main cylinder of coupling and close a cap.
Remove a tank of brake liquid. For this purpose wring out outside clamps on a tank and at the same time take out a tank from a cap.
Take the brake pipeline in front at the left from the holder on the main brake cylinder.
Turn off brake tubes from the main brake cylinder, close brake tubes by means of caps of 1H0 698 311 A from a repair set.
Turn off nuts on the main brake cylinder.
Carefully remove the main brake cylinder from the amplifier of brakes.

Installation
Installation is carried out in return sequence.
At installation pay attention to the next moments.
At assembly of the main brake cylinder and the amplifier of brakes watch the correct landing of a press bar in the main brake cylinder.
Whether the sealing ring between the main brake cylinder and the amplifier of brakes settles down.
Pump over brake system.
After pumping of brake system it is necessary to execute base setup of the sensor of pressure in brake system G201.
VAS 5051 connect and will choose function


<