ATTENTION To course of a pedal of a brake should not stir additional floor rugs.

Fig. 6.57 . A brake pedal (for an automatic transmission): 1–basic arm of pedal knot; 2–six-sided nut, самоконтрящаяся, 20 N · m; 3–finger; 4–brake pedal; 5–bearing loose leaf; 6–basic fastening; 7–support; 8–a bolt with a six-sided head, 8 N · m; 9–sharnirny support; 10-bolt; 11-lock washer; 12-bracket; 13-a bolt with a six-sided head, 8 N · m; 14-switch of a stoplight and sensor of a pedal of a brake

Fig. 6.58 . Tool installation: 1–brake pedal; 2–press bar; 3–fiksatorny uvulas

Establish the T10189 tool on fastening of a press bar in pedals of a brake and a basic arm (fig. 6.58) .

At first press a brake pedal in the direction of the amplifier of brakes a little and keep in this situation.

After that press the T10189 tool in the direction of the amplifier of brakes, thus hold a brake pedal (the pedal should not move to this moment ago). Thus fiksatorny uvulas of 3 fastenings are wrung out by a spherical head of a press bar 2 (fig. 6.58) .

Press the T10189 tool further in the direction of the amplifier of brakes and at the same time to pull a brake pedal in the direction of a seat of the driver. (Thereby the pedal of a brake departs from a spherical head of a press bar).