Transmission
At installation of a transfer case watch the correct position of the driven plug between a transfer case and a transmission.
At installation of support of bearings and the details interfaced to them clear surfaces adjoining to them. Remove from contact surfaces greasing and degrease them.
At replacement of a transfer case fill the unit on the bottom edge of a jellied opening.
Lock rings
Replace lock rings.
Lock rings do not overwind.
Lock rings should adjoin to a landing surface in the flute basis.
Bolts, nuts
To turn off and tighten opposite bolts or nuts of fastening of covers and cases a cross on a cross.
Самоконтрящиеся bolts and nuts replace always.
On all carving connections if necessary grease contact surfaces, and also bolts/screws and nuts only after installation.
All carving openings in which are twisted самоконтрящиеся bolts/screws, should be cleared by a tap of the remains of a carving varnish. Otherwise at the following dismantle their carving can be broken.
Bearings
Needle bearings put to an opravka that party where there is a marking (metal thicker).