Remove a transmission arm.

Fig. 3.102 . Dismantle of a rezinometallichesky support

Squeeze out a rezinometallichesky support (fig. 3.102) .

Fasten a new rezinometallichesky support to T10214/3 emphasis.

Fig. 3.103 . Installation of a new rezinometallichesky support

Press a rezinometallichesky support And by means of T10214/3 emphasis in directing sleeve of T10214/2 while the emphasis of T10214/3 will not rise with the directing T10214/2 plug aflush (fig. 3.103) .

Fig. 3.104 . Installation of a new rezinometallichesky support on an arm

Direct a new rezinometallichesky support by means of the assembly T10214 adaptation to a transmission arm (fig. 3.104) .

For this purpose bolts And or flutes on an emphasis of T10214/3 should be leveled on the center of openings in a transmission arm.

Distances «x» should be equal.

Fig. 3.105 . A press fitting of a new rezinometallichesky support on an arm

After that press a rezinometallichesky support in a transmission arm while the directing T10214/2 plug will not be rotate by hand (fig. 3.105) .

Press a rezinometallichesky support for the length which is not exceeding length of a tube of 3296, if necessary, to pressurize by an emphasis of VW 441 to the limiter.

Establish a transmission arm.