Position 0.

Fig. 1.108 . Key positions in the ignition lock

When in this position (fig. 1.108) insert a key into the ignition lock, steering blocking (the wheel lock opens) and when take out a key automatically acts in film – steering blocking again joins.

Inclusion of ignition 1.

The key should be turned in this position and to release.

Engine 2 start-up.

In this position of a key there is an engine start. Thus all large consumers of the electric power are temporarily disconnected.

Switching off of ignition 3.

The key should be turned in this position and to release.

ATTENTION The starter can be included only at the idle engine (The ignition key in positions 2). If to include a starter at once after engine switching off, starter or engine breakage is possible.

NOTE If to release the ignition key in positions 1, 2 or 3 it automatically comes back to a position 0. If at the left key in the lock of ignition open a door of the driver, the warning signal sounds. The signal reminds that it is necessary to take out the ignition key. If at the idle engine and the included ignition large consumers of the electric power are included (for example, heating of seats, heating of back glass), they after certain time are automatically disconnected, that there was enough energy of the accumulator for engine start-up. To automatic shutdown points the corresponding message on the display of an instrument guard. Small consumers of the electric power, such as parking fires, cannot essentially discharge the accumulator, and they are not disconnected.