The car additional equipment should be carried out by the traction coupling device according to the instruction of the manufacturer.

Fig. 1.125 . Points of fastening of the traction coupling device

Points of fastening And (fig. 1.125) of the traction coupling device are located from below the car.

The size from the middle of a spherical support to the bottom of the car should not be less at all. This requirement remains and at completely loaded car, including load of a spherical support.

Traction coupling device installation

Take into consideration existing instructions concerning the trailer equipment (for example, existence of a separate control lamp), operating in your country.

It is necessary to remove and establish some details, for example, a rear bumper. Besides, bolts of fastening of the traction coupling device should be tightened a dinamometrichesky key, it is necessary to connect a shtekerny nest to a car network also. Professional knowledge and the special tool are for this purpose necessary.

The sizes specified on drawing 1.125 , at a car additional equipment should be precisely observed by the traction coupling device.