VW Touareg repair


+ 1. Operation and car maintenance
- 2. Engine
   + Preliminary checks on the car
   - Mechanical part (petrol engines 3,2L)
      Removal of the power unit
      Removal and installation of the left and right pillows of a support of the engine
      Removal and installation of a conducted disk
      Removal and epiploon installation from a flywheel
      Replacement of an epiploon of a cranked shaft on the party of a damper of krutilny fluctuations
      Replacement of a sealing flange of a cranked shaft on the party of a damper of krutilny fluctuations
      Removal and installation of a cranked shaft
      Removal and installation of a lateral cover
      Removal and installation of a cover of a head of the block of cylinders
      Removal and installation of a head of the block of cylinders
      Check of phases of a gazoraspredeleniye
      Adjustment of phases of a gazoraspredeleniye
      Removal of cam-shafts
      Installation of cam-shafts
      Check of axial shift of cam-shafts
      Marking of cam-shafts
      Replacement of maslosjemny caps
      Check of directing plugs of valves
      Processing of saddles of valves
      Sizes of valves
      Check of pistons, piston rings and diameter of the cylinder
   + Mechanical part (petrol engines 4,2L)
   + Mechanical part (diesel engines 5,0L)
   + Removal and stretcher installation
   + pressurization System (diesel engines)
   + cooling System (petrol engines)
   + cooling System (diesel engines)
   + greasing System (petrol engines)
   + greasing System (diesel engines)
   + injection System (petrol engines)
   + injection System (diesel engines)
   + System of production of the fulfilled gases
   + System топливоподачи (beninovy engines)
   + Tables
+ 3. Transmission
+ 4. Running gear
+ 5. Steering mechanism
+ 6. Brake system
+ 7. Onboard electric equipment
+ 8. Body
+ electric equipment Schemes

Смотрите www.avanta-pro.ru администрирование 1с.


Volkswagen Touareg / Touareg repair>> Engine>> Mechanical part (petrol engines 3,2L)>> Removal and installation of a lateral cover

Fig. 2.54 . Scheme of installation of a lateral cover: 1–a box for conducting; 2, 3 – bolts; 4–Hall sensor; 5–natyazhitel of a chain; 6–sealing ring; 7–bolt; 8–sealing ring; 9–holder; 10-thermostat case; 11-bolt; 12-sealing ring; 13-lateral cover; 14-Hall sensor; 15-sealing ring of round section


Preparation of laying of the block of cylinders for installation

Fig. 2.55 . Openings of laying of a head of the block of cylinders


Clear 3-millimetric openings in laying of a head of the block of cylinders of the remains of old hermetic (fig. 2.55) .
Fill 3 mm of an opening in GBTs laying by AMV 174 004 01 hermetic and grease landing surfaces on a lateral cover and a flange with AMV 176 501 hermetic. At once to establish a lateral cover.

NOTE
At the established head of the block of cylinders of an opening in laying of GBTs are visible only half.



<